SUNX EX-26B

Model EX-26B

Detection distance 6-14mm (center 10mm) (50x50mm white matte paper, with a set distance of 10mm, the diameter of the light spot is φ 1mm)

Minimum detectable object: 0.1mm copper wire (set distance: 10mm)

Less than 15% of the delay action distance [50x50mm using white matte paper]

Repetition accuracy (perpendicular to the detection axis) below 0.05mm (set distance: 10mm)

Power supply voltage 12-24V DC ± 10% pulsation P-P10% or less

Consumption current below 13mA

Output PNP open collector transistor

Maximum current outflow: 50mA

External voltage: below 30V DC (between output and+V)

Remaining voltage: below 2V (when the source current is 50mA), below 1V (when the source current is 16mA)

Output: Equipped with short-circuit protection

Response time below 0.5ms

Working status indicator light orange LED (lights up when output is ON)

Stability indicator light green LED (lights up when stable light enters or when stable light does not enter)

Sensitivity regulator equipped with continuously variable regulator

Working mode switch-

Environmental resistance: Protection structure IP67 (IEC), leak proof type (JIS)

Environmental resistance: Use at an ambient temperature of -25 to+55 ℃ (be careful not to condense or freeze), store at -30 to+70 ℃

Environmental resistance: humidity range of 35-85% RH during use, and 35-85% RH during storage

Environmental resistance: Use environmental illumination incandescent lamp: Light receiving surface illumination below 3000lx

Environmental resistance: withstand voltage AC1000V for 1 minute between all power connection terminals and the casing

Environmental resistance: Insulation resistance between all power connection terminals and the casing, 20M Ω or above, high resistance meter based on DC250V

Environmental resistance: Resistance to vibration frequency of 10-500Hz, double amplitude 3mm (MAX.20G), X, Y, and Z directions for 2 hours each

Environmental resistance: Resistance to impact acceleration of 500m/s2 (approximately 50G), 3 times in X, Y, and Z directions each

Projection element red LED (modulation type)

Projection element: Projection peak wavelength 650nm

Material shell: Polyarylester

Lens: Polyarylester

Cable 0.1mm2 3-core rubber cable, length 2m

Cables with an extension of 0.3mm2 or more can be extended to a total length of 50m

Weight of the main body: about 20g

Packaging weight: approximately 45g

Attachment adjustment screwdriver: 1